* DNS zeigt einen CNAME-Eintrag für auf einem Server, auf dem Volume Activation Services installiert ist. Ich habe wenig Erfahrung mit der Volumenaktivierung, habe aber Folgendes getan: Ich habe den VAMT geöffnet, um die Dinge heute zu überprüfen, und habe festgestellt, dass das Datum der letzten Aktualisierung des Lizenzstatus ~ für die meisten aktiven Systeme war und nichts Neues. The Low Value Rearm designates the upper boundary of the Low Threshold range of values.Īfter entering a Low threshold situation, when a returned value is above the specified Low Value Rearm, the Low Threshold situation ends (for Count-Based Thresholds).Vor meiner Übernahme als Sysadmin hatte die vorherige Volume-Aktivierung auf einen neuen Server umgestellt. If you use the minimum possible value, the Low threshold is disabled because it cannot be crossed. The Low Value must be less than or equal to the designated High Value. The value that below which becomes a threshold situation.
Updates the Threshold's state value to Low for the appropriate Interface. The Monitored Attribute is less than the Low Value for Low Trigger Count cycles. See the following topics for instructions about finding the current polling interval setting: See the tables in About Threshold Settings Provided by NNMi for details. See the currently configured Fault Polling Interval or Performance Polling Interval setting that is influencing the Monitored Attribute you chose, because that is how often NNMi provides a data point. Tip If the polled value represents an average over the configured polling interval, a trigger count of 1 is often appropriate. The High Value Rearm designates the lower boundary of the High Threshold range of values.Īfter entering a High threshold situation, when a returned value is below the specified High Value Rearm, the High Threshold situation ends (for Count-Based Thresholds). If you use the highest possible value, the threshold is disabled because it cannot be crossed. The High Value must be greater than or equal to the designated Low Value. Designate any appropriate integer value (for example, a Management Address ICMP Response Time of 0 or greater milliseconds ). 99.99999999999999 for the highest value less than one hundred. 0.000000000000001 (or 1E-15 in Scientific Notation) for the smallest value greater than zero. Use one of the following:ĭesignate a percentage between 0.00 and 100.00.įor special situations, the following values can be used: The value that above which becomes a threshold situation. If an incident is generated, NNMi closes that incident when the Threshold criteria are no longer met. Generates the related incident (if one is Enabled ). 
Updates the Threshold's state value to High for the appropriate Interface. When these criteria are met, NNMi does the following: The Monitored Attribute is greater than the High Value for High Trigger Count cycles. 
See the tables in About Threshold Settings Provided by NNMi for information about which Monitored Attributes are available for Node Groups. Tip Some of the choices in the Monitored Attribute selection list do not apply in this context.
NNMi applies your changes during the next regularly scheduled monitoring cycle.
Click Save and Close to return to the Monitoring Configuration form.Ĭlick Save and Close. Click Save and Close to return to the Node Settings form. When you configure thresholds using this technique, NNMi uses the assigned Node Group as a filter (only monitoring the threshold for nodes belonging to the specified Node Group). Select the Monitored Attribute you want to monitor and establish the threshold values for that attribute (see Basic Count-Based Threshold Settings table). To delete a threshold definition, select a row and click the Delete icon. To edit a threshold definition, select a row and click the Open icon. To create a threshold definition, click the New icon and select Count-Based Threshold Settings. In the Node Settings form, navigate to the Threshold Settings tab. To edit an Node Settings definition, select a row and click the Open icon. To create an Node Settings definition, click the New icon. From the workspace navigation panel, select the Configuration workspace.
0 kommentar(er)
